Linux ntp not updating Sex chat in dubia
Hi Linux Admin Guys My onsite server is always 15 min slow and seems like NTPD (Network Time Protocol (NTP) daemon) not running properly. we can't seem to get NTP to properly sync the clock. Thanks in advance to all Thanks Chirantan First, I would manually adjust the clock to be closer. And check your ntp config: use a good server and use a drift file. Do not permit those systems to modify the # configuration of this service.You're 900 seconds off assuming your 15 minutes is accurate. First, I would manually adjust the clock to be closer. And check your ntp config: use a good server and use a drift file. Also, do not use those # systems as peers for synchronization.Any other boxes that get ntp through this box will try to sync to this box's local clock. Read the NTP FAQ, especially the part about NTP in real edu Pinging edu [132.2] with 32 bytes of data: Reply from 132.2: bytes=32 time=315ms TTL=232 Reply from 132.2: bytes=32 time=306ms TTL=232 Reply from 132.2: bytes=32 time=332ms TTL=232 Reply from 132.2: bytes=32 time=319ms TTL=232 Ping statistics for 132.2: Packets: Sent = 4, Received = 4, Lost = 0 (0% loss), Approximate round trip times in milli-seconds: Minimum = 306ms, Maximum = 332ms, Average = 318ms C:\Documents and Settings\csahaping org Pinging org [22.214.171.124] with 32 bytes of data: Reply from 126.96.36.199: bytes=32 time=312ms TTL=42 Reply from 188.8.131.52: bytes=32 time=304ms TTL=42 Reply from 184.108.40.206: bytes=32 time=304ms TTL=42 Reply from 220.127.116.11: bytes=32 time=301ms TTL=42 Ping statistics for 18.104.22.168: Packets: Sent = 4, Received = 4, Lost = 0 (0% loss), Approximate round trip times in milli-seconds: Minimum = 301ms, Maximum = 312ms, Average = 305msas advised and documented, i'm trying to use the ntpd -gq instead of ntpdate. Hello, I'm looking for assitance on setting up network time protocol on my HP-ux boxes. If you remove those lines, if this box can't contact a server, you have no ntp service. If this box does not serve others, there is no harm, but I still would not do it. Most servers are probably automatically configured to network time, but if you want to set it up for yourself, or want to change the servers that you are syncing to, here’s the quick article that shows you how to do it.
Visit Stack Exchange but the time never updates, it always stays on the incorrect time (it seems to be pulling time from the ESXi host on reboot unless i set it with ntpdate) I have unticked the box to get the time from the host. 1 u 22 64 377 8.661 -0.036 0.126 -ISP1 22.214.171.124 2 u 36 64 377 11.720 -0.027 0.280 #PRIVATE7 .
# No symbolic links allowed, either, since the daemon updates the file # by creating a temporary in the same directory and then rename()'ing # it to the file.
# driftfile /etc/ntp/drift broadcastdelay 0.008 # # Authentication delay.
# keys /etc/ntp/keys server 132.2 # edu server 126.96.36.199 # org This configuration looks like it is intended as the ntp server for your organization. And it is will to distribute the time to other boxes.
So there might be other boxes that use this box as their ntp server.